IEI Integration NANO-QM57A - Manual (Page 60)

NANO-QM57A EPIC SBC
Page 48
Step 2: Insert the cable connector. Insert the connector into the serial port box header.
See Figure 4-14. A key on the front of the cable connectors ensures the
connector can only be installed in one direction.
Figure 4-14: Single RS-232 Cable Installation
Step 3: Secure the bracket. The single RS-232 connector has two retention screws
that must be secured to a chassis or bracket.
Step 4: Connect the serial device. Once the single RS-232 connector is connected to
a chassis or bracket, a serial communications device can be connected to the
system. Step 0:
4.8 External Peripheral Interface Connection
The following external peripheral devices can be connected to the external peripheral
interface connectors.
ƒ DVI devices
ƒ RJ-45 Ethernet cable connector
ƒ USB devices
ƒ VGA monitor