2 sata drive connection, Figure 4-3: sata drive cable connection – IEI Integration HYPER-KBN User Manual

Page 52

HYPER-KBN

P a g e 40

S te p 3:

Connect the audio devices. Connect speakers to the line-out audio jack.

Connect the output of an audio device to the line-in audio jack. Connect a

microphone to the mic-in audio jack.

S te p 0:

4.4.2 S ATA Drive Co n n e c tio n

The HYPER-KBN is shipped with a SATA drive cable. To connect the SATA drive to the

connector, please follow the steps below.

S te p 1:

Locate the SATA connector and the SATA power connector. The locations of

the connectors are shown in Chapter 3.

S te p 2:

Insert the cable connector. Insert the cable connector into the on-board SATA

drive connector and the SATA power connector. See Figure 4-3.

Figure 4-3: SATA Drive Cable Connection

S te p 3:

Connect the cable to the SATA disk. Connect the connector on the other end

of the cable to the connector at the back of the SATA drive. See Figure 4-3.