IEI Integration HYPER-KBN - Manual (Page 49)

HYPER-KBN
P a g e 37
WARNING:
The installation instructions described in this manual should be carefully
followed in order to prevent damage to the HYPER-KBN, HYPER-KBN
components and injury to the user.
Before and during the installation please DO the following:
 Read the user manual:
o The user manual provides a complete description of the HYPER-KBN
installation instructions and configuration options.
 Wear an electrostatic discharge cuff (ESD):
o Electronic components are easily damaged by ESD. Wearing an ESD cuff
removes ESD from the body and helps prevent ESD damage.
 Place the HYPER-KBN on an antistatic pad:
o When installing or configuring the motherboard, place it on an antistatic
pad. This helps to prevent potential ESD damage.
 Turn all power to the HYPER-KBN off:
o When working with the HYPER-KBN, make sure that it is disconnected
from all power supplies and that no electricity is being fed into the system.
Before and during the installation of the HYPER-KBN DO NOT:
 Remove any of the stickers on the PCB board. These stickers are required for
warranty validation.
 Use the product before verifying all the cables and power connectors are
properly connected.
 Allow screws to come in contact with the PCB circuit, connector pins, or its
components.