WEATHER GUARD 1200 - Manual (Page 8)

Page 8 of 8
Tool Box Mounting Procedure
If a bed rail mounted tool box is to be in-
stalled with the Model 1200 or 1205, use
the 1/4" thick shims, Part M, that are pro-
vided in the tool box mounting hardware
kit (came with the ATR TM ) along with the
"J" bolts (supplied with the tool box). This
will insure a level mounting of the tool box
on the truck bed rails.
Where the mounting rails (Parts D, E, & F)
obstruct the use of a "J" Bolt, use a 5/16-
18 x 3/4" self-tapping bolt, Part N, in its
place which is supplied in the tool box
mounting hardware kit that came with the
ATR TM .
Place the tool box in the desired location
on the truck and trace the mounting slot in
the bottom of the tool box directly onto the
mounting rail.
Move the tool box out of the way and drill a
1/4" dia. hole 3/4" from the inside edge of
the mounting rail. (See diagram)
Reset the tool box in the desired position
and install the 5/16-18 x 3/4" self tapping
bolt and fender washer. The fender
washer came with the "J" bolts. If needed,
use the 1/4" shims, Part M, to level the tool
box on the truck.
Part N
5/16-18 x 3/4"
Self Tapping Bolt
Drill 1/4" Dia. Hole
3/4"
Part M
1/4" Shim
Shim Pad
(Cut from the
tool box
mounting pad)
Ladder Rack
Fasteners
Supplied
with Box
"J" Bolt
Supplied
with Box
See Drilling Detail Above
Do not overtighten the
self-tapping bolts.
IMPORTANT!