WEATHER GUARD 1210 - Manual (Page 4)

Page 4 of 6
STEP
THREE
STEP
FOUR
Separate the mounting clamps by remov-
ing the 5/16-18 X 3" carriage bolt from the
drivers side rear mounting clamp, Part U,
and the passenger side rear mounting
clamp, Part V.
Install the mounting clamps around the rear
legs. Leaving a 1/4" gap (see diagram) be-
tween the clamps and cross member. Re-
install the 5/16-18 carriage bolts and
tighten to 15 foot pounds of torque. The
solid side of the clamps must face towards
the rear of the vehicle.
PART W
PART U- Drivers
Side
Slide the universal front mounting clamps,
Part W, onto both the driver and passen-
ger side of the installed front cross mem-
ber from the Model 1200 or Model 1205.
Leaving 1/4" gap (see diagram) between
the clamps and legs. Tighten the 5/16"
hardware to 15 foot pounds of torque.
PART V- Passenger
Side
Not Shown
5/16-18 X 3"
Carriage Bolt
1/4" Gap
1/4" Gap
STEP THREE
STEP FOUR
Rear View Front View