Warner Electric PCC-825, PCC-1000, PCC-1225, PCC-1525 - Manual (Page 10)

10 Warner Electric • 800-825-9050 P-206 • 819-0519
Step 4 Slide the armature-adapter
assembly up against the retainer ring.
Step 5 Insert the bushing into the retainer
ring side of the splined hub. The
clearance holes in the bushing flange
should line up with the tapped holes
in the splined hub. (See Figure 6)
D. Mounting the Armature and Hub
Assembly
1. Slide the complete armature and hub
assembly onto the shaft until the armature
face touches the magnet face.
(See Figure 7)
C. Assembling the Armature and Hub
The clutch-coupling units contain spline
drive armatures and hubs. The armatures
are shipped with a built-in autogap spring
accessory. This device automatically
maintains a gap of about 1/32" between the
armature and magnet faces for the life of the
unit.
These units are shipped with the armature,
splined armature adapter, and autogap already
assembled. The splined hub, retainer ring, and
bushing are shipped as separate parts.
Follow these instructions to assemble the
splined armature assembly and hub:
Step 1 Place the armature-splined adapter
assembly on a flat surface with the
segmented side up.
Step 2 Push the splined hub, with the
retainer ring groove down, through
the autogap spring and splined
armature adapter. (See Figure 4)
Step 3 Turn the armature-adapter assembly
over, and insert the retainer ring in the
groove. (See Figure 5)
Figure 6
Figure 7
Figure 4
Figure 5