Teledyne LeCroy QPHY-SAS3 - Manual (Page 6)

USING QUALIPHY SAS3
QualiPHY SAS3 guides the user, step-by-step, through each of the tests in conformance with the T10
SAS-3 specification as described by the UNH-IOL SAS-3 Physical Layer Test suite. To do this, the
user must set up a test session.
Before beginning testing, users choose the test configuration they wish to run. There are nine pre-loaded
test configurations. They are:
• 12.0 Gbps Tx tests using Live (Acquisition) Data
• 12.0 Gbps Tx tests using Saved Data
• Demo of 12 Gbps Tx tests using Saved Data
• 1.5 Gbps Tx tests using Live (Acquisition) Data
• 1.5 Gbps Tx tests using Saved Data
• 3.0 Gbps Tx tests using Live (Acquisition) Data
• 3.0 Gbps Tx tests using Saved Data
• 6.0 Gbps Tx tests using Live (Acquisition) Data
• 6.0 Gbps Tx tests using Saved Data
These pre-loaded configurations provide quick and easy ways to begin compliance testing (see the
QPHY-SAS3 Test Configurations section for details on each configuration). If the user does not want
to run any of these configurations, they can create their own custom configuration (see the Creating
Custom Configurations section for details).
The pre-loaded configurations are set up to run all of the tests required for compliance. If this is not what
the user wants, the variables can be modified (see the QPHY-SAS3 Variables section of this manual).
The variables are pre-loaded with the standard settings for compliance testing; however, the user may
choose to create their own configuration with the variables set as desired.
6 922545 Rev A