Teledyne LeCroy QPHY-SAS3 - Manual (Page 45)

QPHY-SAS3 Software Option
Using Fast Edge
The Fast Edge deskew technique will use the Fast Edge output on the oscilloscope to deskew C2 and
C3.
The first step is to connect C2 to the Fast Edge connection on the oscilloscope. The connection to C2
should the cables and DC blocks which will be used during the testing.
Figure 40 – Fast Edge – Step 1 Prompt
Before moving on to Step 2 the display on the oscilloscope screen should appear as below. F2 is setup to
be used for the deskew calculation of C2.
Figure 41 – Fast Edge – Step 1 Oscilloscope Display
922545 Rev A 45