Qphy-sas3 test configurations – Teledyne LeCroy QPHY-SAS3 User Manual

Page 16

QPHY-SAS3 TEST CONFIGURATIONS

Configurations include variable settings and limit sets as well, not just test selections. See the QPHY-
SAS3 Variables section for a description of each variable value and its default value.

12.0 Gbps Tx tests using Live (Acquisition) Data

This configuration will run all of the tests except for the WDP test and the legacy VMA and VPP tests.
The limit set in use is SAS3-12G. All of the variables are set to their default settings except Bitrate is set
to 12e9.

12.0 Gbps Tx tests using Saved Data

Demo of 12.0 Gbps Tx tests using Saved Data

This configuration will run all of the tests on the demo waveforms (available from
www.teledynelecroy.com). The limit set in use is SAS3-12G. All of the variables are set to their default
settings except Bitrate is set to 12e9, Test Mode is set to Use Saved Data, Path to saved Waveforms
for offline tests is set to D:\Waveforms\SAS3\Demo and Demo Mode is set to Yes.

1.5 Gbps Tx tests using Live (Acquisition) Data

This configuration will run all of the tests except for the WDP test and the Equalization tests. The limit set
in use is SAS3-1.5G. All of the variables are set to their default settings except Bitrate is set to 1.5e9.

1.5 Gbps Tx tests using Saved Data

3.0 Gbps Tx tests using Live (Acquisition) Data

This configuration will run all of the tests except for the WDP test and the Equalization tests. The limit set
in use is SAS3-3G. All of the variables are set to their default settings except Bitrate is set to 3e9.

3.0 Gbps Tx tests using Saved Data

6.0 Gbps Tx tests using Live (Acquisition) Data

This configuration will run all of the tests except for the WDP test and the Equalization tests. The limit set
in use is SAS3-6G. All of the variables are set to their default settings except Bitrate is set to 6e9.

6.0 Gbps Tx tests using Saved Data

922545 Rev A