Teledyne LeCroy QPHY-SAS3 - Manual (Page 46)

The second step is to disconnect C2 from the Fast Edge and connect C3. The connection to C3 should
the cables and DC blocks which will be used during the testing.
Figure 42 – Fast Edge – Step 2 Prompt
Before moving on to Step 3 the display on the oscilloscope screen should appear as below. F2 has been
saved to M2 and F3 is setup to be used for the deskew calculation of C3.
Figure 43 – Fast Edge – Step 2 Oscilloscope Display
46 922545 Rev A