Teledyne LeCroy QPHY-SAS3 - Manual (Page 50)

APPENDIX B: FILE NAME CONVENTIONS FOR SAVED WAVEFORM
DATA
When live tests are made, the acquired waveforms are stored using these file names. If there is data
which has been already acquired, to perform tests using this package, the files must be renamed to
conform to these conventions: Please note (at this time) there is no distinction between bit rates, so
please use different folders for results at 12, 6, 3, and 1.5 Gbps.
These files have semi-rigid record length (time duration) requirements for performing the needed tests
(shown in table below)
Test Signal Type Tx+ Tx- Recommended Record
duration
Out of Band or COMINIT OOB_p OOB_n 1 microsecond (or
100ns/div)
Compliance Jitter Test
Pattern CJTPAT_p CJTPAT_p 100 microseconds (or
10usec/div)
High Frequency Test
Pattern (10101010…) HFTP_p HFTP_n 500 microseconds (or
50us/div)
High Frequency Test
Pattern (10101010…)
with SSC down-spreading HFTP-SSC-DOWN_p HFTP-SSC-DOWN_n 500 microseconds (or
50us/div)
High Frequency Test
Pattern (10101010…)
with SSC center-
spreading HFTP-SSC-CENTER_p HFTP-SSC-CENTER_n 500 microseconds (or
50us/div)
Medium Frequency Test
Pattern (11001100…) MFTP_p MFTP_n 500 microseconds (or
50us/div)
Medium Frequency Test
Pattern (11001100…) with
SSC down-spreading MFTP-SSC-DOWN_p MFTP-SSC-DOWN_n 500 microseconds (or
50us/div)
Medium Frequency Test
Pattern (11001100…) with
SSC center-spreading MFTP-SSC-
CENTER_p MFTP-SSC-
CENTER_n 500 microseconds (or
50us/div)
Scrambled Zero SCR_0_p SCR_0_n 100 microseconds (or
10us/div)
D30.3 pattern D30p3_p D30p3_n 100 microseconds (or
10us/div)
IDLE Reference 0 IDLE_REF0_p IDLE_REF0_n 20 microseconds (or
2us/div)
IDLE Reference 1 IDLE_REF1_p IDLE_REF1_n 20 microseconds (or
2us/div)
IDLE Reference 2 IDLE_REF2_p IDLE_REF2_n 20 microseconds (or
2us/div)
50 922545 Rev A