How to run the saswdp script, Physical layer test suite) – Teledyne LeCroy QPHY-SAS3 User Manual
Page 41
QPHY-SAS3 Software Option
HOW TO RUN THE SASWDP SCRIPT
The SASWDP script is required for running the Waveform Distortion Penalty (5.3.9) test. This script can
be obtained from the T10 organization website
. A valid T10 login is
required for downloading this download.
Note: As of March 2nd, 2014 this script can be found at the following site but this is subject to change:
1. This script must be run from the same directory as the stressor, symbol and waveform data files.
• The stressor file is included when the script is downloaded from the T10 website (this file is
also included with QPHY-SAS3).
• The symbol and waveform data files are created when the WDP test is run from QPHY-
SAS3.
2. If MATLAB is installed on the oscilloscope:
• Unzip the 09-015r0.zip file to the D:\Waveforms\SAS3 directory.
i. The link to this file is provided above.
3. If MATLAB is installed on a separate PC
• Unzip the 09-015r0.zip to a temporary directory on the PC
• Copy the sas2_symbol.txt and sas2_waveformData.txt files to the same directory.
4. Run the SASWDP.m script.
Figure 37 - Example BER Map with WDP Results (Figure 5.3.9-3 from UNH-IOL SAS-3 12Gbps
Physical Layer Test Suite)
922545 Rev A
41