Teledyne LeCroy SAS Verification Test Descriptions User Manual

Page 63

The University of New Hampshire

InterOperability Laboratory

Serial Attached SCSI Consortium

SAS Link and Transport Layer Test Suite v0.13

Test 10.1.8 - SCSI CDB – READ(10)

Purpose: To determine that the DUT, an SSP Target port, properly handles a READ(10) command.

References:

SBC-2 5.8

Resource Requirements: SAS Protocol Analyzer and Generator.

Revision History: September 28, 2004

Test Setup: The DUT and the Testing Station are physically connected.

Test Procedure (SSP Target):

• The Testing Station should start and complete a Phy Reset sequence followed by an Identify sequence

with the DUT. Since the DUT is a target the Testing Station should transmit an Identify Address frame
indicating that it is a SAS Initiator.

• The Testing Station should open an SSP connection to the DUT and transmit a SCSI READ command

for 2048 bytes. Close the connection

• The DUT should open a connection to the DUT and transmit 4 512 byte DATA frames. The Testing

Station should transmit ACK for each received frame.

• Allow the DUT to open an SSP connection and transmit a SCSI RESPONSE frame to the received

command.

Observable Results: Verify that the DUT transmits RESPONSE frame indicating that the command completed
with GOOD status.