Teledyne LeCroy SAS Verification Test Descriptions User Manual
Sas verification test descriptions, June 2010
Protocol Solutions Group
3385 Scott Blvd., Santa Clara, CA 95054
Tel: +1/408.727.6600
Fax: +1/408.727.6622
SAS Verification Test Descriptions
June 2010
Table of Contents
SAS Link and Transport Layer Test Suite 2
SAS 2.0 Speed Negotiation 137
NACA Test 186
Table of contents
Document Outline
- SAS Verification Test Descriptions
- SAS Verification Tests
- SAS_2.0_Speed_Negotation_v0.4.pdf
- MODIFICATION RECORD
- ACKNOWLEDGEMENTS
- INTRODUCTION
- TEST ORGANIZATION
- REFERENCES
- GROUP 1: Speed Negotiation Window Three
- OVERVIEW
- Test 6.7.1.1: Support for SNW-3
- Test 6.7.1.2: SNTT: Total Time
- Test 6.7.1.3: SNNT: Remainder Time
- Test 6.7.1.4: Rate Change Delay Time
- Test 6.7.1.5: Phy Capabilities Bits – Start Bit
- Test 6.7.1.6: Phy Capabilities Bits – TX SSC Type
- Test 6.7.1.7: Phy Capabilities Bits – Reserved Bits
- Test 6.7.1.8: Phy Capabilities Bits – G1 WITHOUTs SSC
- Test 6.7.1.9: Phy Capabilities Bits – G1 WITH SSC
- Test 6.7.1.10: Phy Capabilities Bits – G2 WITHOUT SSC
- Test 6.7.1.11: Phy Capabilities Bits – G2 WITH SSC
- Test 6.7.1.12: Phy Capabilities Bits – G3 WITHOUT SSC
- Test 6.7.1.13: Phy Capabilities Bits – G3 WITH SSC
- Test 6.7.1.14: Phy Capabilities Bits – Reserved Bits
- Test 6.7.1.15: Phy Capabilities – Parity Bit
- Test 6.7.1.16: Receive Bad Parity
- Test 6.7.1.17: No Common Speeds
- OVERVIEW
- GROUP 2: Train Speed Negotiation Window
- NACA-Test-Revised.pdf