Teledyne LeCroy SAS Verification Test Descriptions - Manual (Page 58)

The University of New Hampshire
InterOperability Laboratory
Serial Attached SCSI Consortium
57 SAS Link and Transport Layer Test Suite v0.13
Test 10.1.3 - SCSI CDB – START STOP
Purpose: To determine that the DUT, an SSP Target port, properly handles a START STOP command.
References:
SBC-2 5.19
Resource Requirements: SAS Protocol Analyzer and Generator.
Revision History: February 8, 2005
Test Setup: The DUT and the Testing Station are physically connected.
Test Procedure (SSP Target):
• The Testing Station should start and complete a Phy Reset sequence followed by an Identify sequence
with the DUT. Since the DUT is a target the Testing Station should transmit an Identify Address frame
indicating that it is a SAS Initiator.
• The Testing Station should open an SSP connection to the DUT and transmit a SCSI START STOP
command to the DUT. Close the connection
• Allow the DUT to open an SSP connection and transmit a RESPONSE frame to the received
command.
Observable Results: Verify that the DUT transmits RESPONSE frame indicating that the command completed
with GOOD status.