beautypg.com

Compliance test – Teledyne LeCroy TA700 Compliance User Guide User Manual

Page 15

background image

MP_20
IUT never starts cycle unless GNT# is asserted. (3.4.1)


Three memory read commands with one data phase for each is requested to check for IUT
FRAME# assertion only after GNT# is asserted.

In this test, first the following message is shown:


And then the following message is displayed requesting the data transfer.

This test requires the IUT to be plugged on top of TA660. Therefore this test can only be
done with PCI analyzers and not CPCI. MP_20 will not be executed by the software when
user is using TA600C.

Compliance Test

15

Rev. 1.0

See also other documents in the category Teledyne LeCroy Equipment: