Teledyne LeCroy PETrainer Scripting Language Reference Manual - Manual (Page 7)

Teledyne LeCroy PETrainer Scripting Language
2
2 Command List
COMMAND MODIFIERS Comment
Packet TLP, DLLP, OrderedSet, Raw,
Sends a packet.
Idle <# of ns> Sends idle symbols (D0.0).
Link L0, L1, L0s, HotReset, Disabled,
Recovery, Detect, LTSSMOff, InitFC Sets a link condition.
Config General, FCTx, FCRx, TLP, AckNak,
Transactions, Link, Definitions Configures the PETrainer™
Wait TLP, DLLP, Error, LinkCondition,
BOB, Payload, User Waits for the condition specified.
Include Includes a PETrainer script file.
Branch TLP, DLLP, Error, Link, BOB,
Payload, User Enables/disables an interrupt for
the specified condition.
Proc Begin, End Declares the procedure to be
used in a branch statement.
Loop Begin, End Creates a PETrainer loop.
Repeat Begin, End Repeats traffic some number of
times.
Template TLP, DLLP, OrderedSet, Raw,
Creates a template for a packet
that can be used in the Packet
command.
AddressSpace Read, Write Reads/Writes address space.
FastTransmit Setup, Start, Pause, Continue, Stop
Defines and controls high-
performance generation.
Note: Available only for the
Summit Z2-16™ and Summit Z3-
16 Trainers.
Send
MRd32, MWr32
MRd64, MWr64 Defines a sequence of packets to
send once, a number of times, or
repeatedly. Available only in a
Setup command section of a
FastTransmit block.
Note: Available only for the
Summit Z2-16 and Summit Z3-16
Trainers.