Teledyne LeCroy PETrainer Scripting Language Reference Manual - Manual (Page 38)

Teledyne LeCroy PETrainer Scripting Language
33
Note:
Command supported only by Z3 Trainer.
5.8 Link = Detect
Tells the PETrainer™ to immediately bring the Link down. In this state, the LTSSM drives all of the
PCI Express lanes to electrical idle. Before the lanes go to electrical idle, a single electrical idle ordered
set is transmitted. Applies while in any state.
Note:
Command supported only by Z3 Trainer.
5.9 Link = LTSSMOff
Disables the LTSSM. This essentially means that the PETrainer is not responsible for managing the link
state. Instead, the user is free to transmit ordered sets, DLLP's, and RAW packets blindly.
Note: Command only supported by ML and EML Trainers.
5.10 Link = InitFC
Starts the flow control initialization state machine.
5.11 Link = PERST
Sends a PERST# signal for the period specified.
Parameter
Values Default Comment
Duration In ns (rounded to nearest 8) 1000 Duration of the PERST# signal
Note: This command is supported by the PETrainers ML and EML. These legacy products are no longer
supported by PETrace 7.00 and newer.
5.12 Link = PERST_Assert
In host mode, the Z3 trainer will drive a low in the bus for PERST#.
Note:
Command supported only by Z3 Trainer.
5.13 Link = PERST_Deassert
In host mode, the Z3 Trainer will release PERST# and the bus will drive PERST# high.
Note:
Command supported only by Z3 Trainer.
5.14 Link = 2_5
Initiates speed switch to 2.5 GT/s data rate. The system attempts to switch if the link is in the L0 state at
5.0 GT/s data rate.
Note: This command only applies to the Summit Z2-16 and Summit Z3-16 Trainers.