Teledyne LeCroy PETrainer Scripting Language Reference Manual - Manual (Page 39)

Teledyne LeCroy PETrainer Scripting Language
34
5.15 Link = 5_0
Initiates speed switch to 5.0 GT/s data rate. The system attempts to switch if the link is in the L0 state at
2.5 GT/s data rate, and both Summit Z2-16 and Summit Z3-16 Trainers and the DUT advertise the 5.0
GT/s data rate.
Note: This command only applies to the Summit Z2-16 and Summit Z3-16 Trainers.
5.16 Link = 8_0
Initiates speed switch to 8.0 GT/s data rate. The system attempts to switch if the link is in the L0 state at
2.5 GT/s or 5.0 GT/s data rate, and the Summit Z3-16 Trainer and the DUT advertise the 8.0 GT/s data
rate. 8.0GT/s data rate is available only on the Summit Z3-16 Trainer.
Note: This command only applies to the Summit Z3-16 Trainer.
5.17 Link = Xn
Transitions the width of the link to the one specified by the command. Applies only in L0 state.
Note:
Command supported only by Z3 Trainer.