Teledyne LeCroy PETrainer Scripting Language Reference Manual - Manual (Page 4)

Teledyne LeCroy PETrainer Scripting Language
iv
5.15 Link = 5_0 ........................................................................ 34
5.16 Link = 8_0 ........................................................................ 34
5.17 Link = Xn 34
6 Config Command........................................................ 35
6.1 Config = General .............................................................. 35
6.2 Config = FCTx .................................................................. 37
6.3 Config = FCRx ................................................................. 38
6.4 Config = TLP .................................................................... 39
6.5 Config = AckNak .............................................................. 40
6.6 Config = Transactions ...................................................... 42
6.7 Config = Link .................................................................... 43
6.8 Config = Definitions .......................................................... 44
6.9 Config = SendInterrupt ..................................................... 46
6.10 Config = NVMe ................................................................ 47
6.11 Config = NVMeDriveErrorInjection ................................... 48
7 Wait Command ........................................................... 50
7.1 Wait = TLP ....................................................................... 50
7.2 Wait = LinkCondition ........................................................ 53
7.3 Wait = Payload ................................................................. 54
7.4 Wait = User ...................................................................... 56
7.5 Wait = FastTransmitIdle ................................................... 57
7.6 Additional “Wait” Modifiers ............................................... 58
8 Branch Command....................................................... 59
8.1 Branch = ....................................................... 59
8.2 Branch = Disable ............................................................. 61
9 Proc Command ........................................................... 62
9.1 Proc = Begin .................................................................... 62
9.2 Proc = End ....................................................................... 62
10 Loop Command .......................................................... 63
10.1 Loop = Begin ................................................................... 63
10.2 Loop = End ...................................................................... 63
11 Repeat Command ....................................................... 64
11.1 Repeat = Begin ................................................................ 65
11.1.1 Counter Parameter ...................................................... 65
12 Template Command ................................................... 68
13 Include Command ...................................................... 70
14 AddressSpace Command .......................................... 71
14.1 AddressSpace = Read ..................................................... 72
14.2 AddressSpace = Write ..................................................... 73