Teledyne LeCroy PETracer ProtoSync Software User Manual - Manual (Page 89)

PETracer Software User Manual Chapter 8: Reports and Tools
Teledyne LeCroy
83
Chapter 8: Reports and Tools
Reports assist you in analyzing traffic recorded by the Analyzer. The available reports
are:
• File Information: To view general information about the CATC Trace file.
• Error Summary: To view a count of errors in a CATC Trace file.
• Traffic Summary: To view a summary of protocol-related information in the
CATC Trace file summary information about a selected group of items in the
CATC Trace file (such as a count of particular frame or packet types).
• Bus Utilization: To display information on bandwidth usage for the transmit and
receive channels.
• Link Tracker: Displays a detailed chronological view of events.
• Data Flow: Shows marker, packet, direction, type, length, address, payload, hand-
shake, and timestamp information.
• Trace Navigator: Navigates within the CATC Trace to view the location of errors
and triggers, narrow the range of traffic on display, and jump to any point in the
CATC Trace.
• LTSSM Flow Graph: Shows a state diagram of bus activity.
• Packet Header: Shows packet header information
• Packet Data: Shows packet information.
• Configuration Space: Displays a Configuration Space.
• Metrics: Measures key operating parameters.
• TC to VC Mapping: To display how Traffic Classes are mapped to Virtual Channels (to
simplify navigation) and how the CATC Trace display was changed (for example, in Split
Transactions).
• Timing Calculations: To view timing measured between two events set within the
CATC Trace file.
• Run Verification Scripts: Allows you to check errors, link transactions, split trans-
actions, metrics, ordered sets, replays, DLLPs, and TLPs.
Reports are available from the Report menu and buttons on the Tool bar. Tools are
available from the Tools menu.