Teledyne LeCroy PETracer ProtoSync Software User Manual - Manual (Page 131)

PETracer Software User Manual Chapter 8: Reports and Tools
Teledyne LeCroy
125
All the fields in this dialog are required and editable. Make sure that the information
entered is correct. Click on any field and the description displays in the bottom read-only
box (see figure on next page). Some important fields are described below:
• Device: There is only one device node, (support for multiple device trace decod-ing
will be available in a later release). If there is no device node, then the user can add
a device node by clicking the Add Device button.
• MBAR: The 64-bit main address bar (i.e. BAR1:BAR0). Without this value decoding
cannot be done. It should be in "0x" hex format.
• Queues: Under this node the user can add more missing nodes to decode the cur-
rent trace. Click the Add Queue or Delete Queue button to add or delete a queue
node. Type based on the user selection. The following Node types are known.