Amana RSS - Manual (Page 88)

FIRE OR EXPLOSION - TO AVOID THE RISK OF ELECTRICAL SHOCK, PERSONAL
INJURY, OR DEATH, DISCONNECT POWER TO THE OVEN BEFORE SERVICING.
DISASSEMBLY PROCEDURES - RST MODELS
87 RC231002 Rev. 3
4. On models without sealed burners, remove eight (8)
screws to burner box.
On models with sealed burners, the burner caps and
eight (8) main top mounting screws must be removed.
Remove eight (8) burner box mounting screws.
5. Remove bake and broil ignitors. Remove bake and
broil burners.
6. Remove lower burner box.
7. Remove oven light lens, light bulb and housing.
8. On ERC models, remove three (3) screws to probe,
disconnect wire harness, and remove probe.
On Models without ERC, remove two (2) screws to
capillary tube shield and remove shield. Remove
capillary tube through top of oven cavity.
9. Remove four (4) screws in top back wall of oven and
ten (10) screws securing top combustion chamber to
oven liner. Remove two (2) screws to chip cover and
four (4) screws at top front of oven liner.
10. Remove storage drawer. Remove one (1) screw from
each storage drawer track and remove track from
range.
11. Remove eight (8) screws to rear cover.
12. Remove twenty-eight (28) screws securing rear insu-
lation retainer. Remove two (2) screws holding
dilution flue to rear retainer.
13. Remove four (4) screws securing on backguard sup-
port to side panel (either side can be removed).
14. Push down on rear insulation retainer and push up
and in on oven liner mounting bracket to free bracket
from retainer.
15. Grasp lip of tank and gently maneuver the tank
forward to remove it from the range.
16. Remove two (2) screws to each oven liner mounting
bracket.
17. Reinstall brackets on replacement liner. Reverse
procedure to reinstall replacement liner.
18. Reconnect range to electricity and gas. Be sure to
check gas connections for possible leaks. Use a leak
detector or soap solution.
OVEN LINER DISASSEMBLY (RSS MODELS)
1. Disconnect electricity at main disconnect plug. Turn
off gas supply and disconnect range from gas supply.
2. Remove burner grates, main top, and top burners.
3. Remove burner box.
4. Remove thermostat capillary bulb from capillary shield,
and remove capillary shield.
5. Remove oven bottom, oven burner ignitor and oven
burner. Also remove broil burner ignitor and broil
burner.
6. Remove oven light lens and oven light socket.
7. Remove the ten (10) screws that surround the re-
cessed cavity for the broil burner.
Figure 81
8. Remove the four (4) screws mounting on the rear of
the oven liner. Remove screws securing front top lip
of liner to front frame.
Figure 82
9. Remove the twenty-four (24) screws that secure the
recessed cavity fro the oven burner.
Figure 83
10. Remove rear cover plate and screws that secure the
insulation retainer.