Amana RSS - Manual (Page 10)

INSTALLATION INSTRUCTIONS
9 RC231002 Rev. 3
Figure 5A
IN MOBILE HOMES:
Any installtion in a mobile home must conform with the
Manufactured Home Consutruction and Safety Standards.
Title 24CFR, Part 32-80 (in Canada, CSA standard Z240,4-
1) or when such standard is not applicable, with the local
codes.
For mobile home installation it is necessary to use alter-
nate METHOD #2 (see Figure 5A) to secure range to floor.
See rating label to determine if range can be used in this
application.
ANY OPENINGS IN THE WALL BEHIND THE RANGE
OR THE FLOOR UNDER THE RANGE MUST BE SEALED.
ELECTRICAL CONNECTIONS
FOR GROUNDING - THIS APPLIANCE MUST BE
ELECTRICALLY GROUNDED IN ACCORDANCE WITH
LOCAL CODES, OR, IN THE ABSENCE OF LOCAL
CODES, WITH THE NATIONAL ELECTRIC CODE, ANSI/
NFPA NO. 70-1990. FAILURE TO FOLLOW THESE
INSTRUCTIONS MAY RESULT IN ELECTRIC SHOCK,
PERSONAL INJURY OR DEATH.
The power cord on this appliance is equipped with a three-
prong (grounding) plug which mates with standard three-
prong (grounding) receptacles.
Where a standard two-prong wall receptacle is en-
countered, it is the personal responsibility and obligation
of the customer to have it replaced with a properly grounded
three-prong wall receptacle.
FIRE OR EXPLOSION
H A ZA RD
Where local codes permit, a TEMPORARY CONNEC-
TION may be made to properly ground a two-prong wall
receptacle by the use of an adaptor which is available at
most local hardware stores.
An adaptor plug can temporarily be used (see Figure 4)
preferably with polarized male blades. If an unpolarized
adaptor plug must be used, determine which is the "hot"
side and ground. Place an identifying mark on the adaptor
to assure proper polarization in the future.
Figure 6
ATTACHING THE ADAPTOR GROUND WIRE TO THE
WALL RECEPTACLE COVER SCREW DOES NOT
GROUND THE APPLIANCE UNLESS THE COVER
SCREW IS GROUNDED THROUGH THE HOUSE
WIRING.
If there is any doubt as to whether the wall receptacle is
properly grounded, the customer should have it checked
by a qualified electrician.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR
REMOVE THE THIRD (GROUND) PRONG FROM THE
POWER PLUG.