Staub Electronics SM-CS-ART2-XL STRONG - CONTRACTOR SERIES ARTICULATING MOUNT FOR 47 - 90 FLAT PANEL TVS - Manual (Page 5)

Step 5: Attaching Screen to Wall Arm Assembl y
Lift the display and hook the two Hex head screws
with metal washers in grooves on top of the Mounting
Head.Insert two more Hex head screws with washers in
bottom two holes of the Mounting Head, securing it to
the Adapter Plate. Then tighten all four screws with the
Allen Wrench.
NOTE: For demonstration purposes, the wall has been
omitted from the illustrations.
NOTE: This procedure will require two persons.
Ensure that the arm is set to its maximum negative
tilt prior to attaching the display.
Step 6: Running Cables
Run as shown and install Wire Management Caps.
NOTE: Make sure cords have enough slack to allow
full movement of the arm.
Wire Management
Caps
Figure 14
Rubber Adhesive
Safety Pads (W)
Figure 15
PG 4