Staub Electronics SM-CS-ART2-XL STRONG - CONTRACTOR SERIES ARTICULATING MOUNT FOR 47 - 90 FLAT PANEL TVS - Manual (Page 3)

INSTALLATION
Step 1: Use template to mark mounting
hole locations for flange bolts
Note: Corners fold up to catch debris, if needed.
Step 2: Pre-drilling
For Mounting on a Stud Wall
Pre-drill holes into studs using a 1/4” drill bit.
WARNING:
Tighten screws so that wall plate is firmly attached,
but do not overtighten. Overtightening can dam-
age the screws, greatly reducing their holding
strength.
Make sure that mounting screws are anchored
into the center of the studs. The use of a stud
finder is highly recommended.
For Mounting on a Concrete Wall
Pre-drill holes into concrete using 5/16” drill bits.
Insert concrete wall anchors and tap in with hammer,
if necessary.
WARNING:
When installing wall arm assembly on cinder
block, verify first that you have a minimum of
1-3/8” of concrete thickness to be used for the
concrete anchors. Do not drill into mortar joints!
Be sure to mount in a solid part of the block,
generally1” minimum from the side of the block.
Cinder block must meet ASTM C-90 specifications.
It is suggested that a standard electric drill on slow
setting is used to drill the hole instead of a hammer
drill to avoid breaking out the back of the hole
when entering a void or cavity.
Concrete must be 2000 psi density minimum.
Lighter density concrete may not hold con-
crete anchor
.
Make sure that the supporting surface will safely
support the combined load of the equipment
and all attached hardware and components.
Drill holes and
insert anchors.
Place wall assembly
arm with plate
over anchors and
secure bolts.
Tighten all
fasteners.
flange bolts
wall plate
concrete
wall
Correct
concrete concrete
plaster/
drywall
plaster/
drywall
Incorrect
Cuta
w
ay V
ie
w
PG 2