IAI America LSA-L15SS - Manual (Page 60)

6. Maintenance and Inspection
54
6.5.3 Operation Check
1) Move the slider to check the tension of the stainless steel sheet.
Move the slider to check the tension. Specifically, check if the stainless steel sheet is
positioned uniformly on the right and left without presenting meandering or waving over the
entire stroke range.
If the stainless steel sheet is not uniformly positioned on the right and left or is waving, repeat
the adjustment.
2) Securely tighten the thin-head screws that have been loosened with a 7mm-sized hex wrench
to affix the stainless steel sheet in position.
Alternately tighten the two fixed screws that have been temporarily tightened and
finally tighten them with the even torque. If the tightness on the two nuts is uneven,
the sheet may meander or lift up.
Tightening torque for fixed screws 359N•cm (36.7kgf•cm)
Move the slider to check once again if the stainless steel sheet is tensioned properly. Lastly,
remove the check lines using alcohol, etc.