IAI America LSA-L15SS - Manual (Page 59)

6. Maintenance and Inspection
53
4) Adjusting the Stainless Steel Sheet Tension
Adjust the stainless steel sheet in the direction of the arrow until the check lines on the side
covers are offset from the check line on the stainless steel sheet by 0.5mm. (Refer to the
enlarged view of A.)
(The stainless steel sheet is gripped on with the magnets. Detach the sheet in a manner of
peeling it once from one edge.)
DETAIL A
DETAIL A
Offset
Stainless steel sheet
Side covers
Move the stainless steel sheet in the direction of the arrow to fine-tune the sheet position until the
check lines on the side covers are offset from the check line on the stainless steel sheet by
0.5mm.
Once this adjustment is complete, an approximately 1mm clearance has been achieved
between the top surface of the stainless steel sheet and the back of the slider cover at the
center of the slider cover.
5) After the sheet has been positioned, loosely tighten the fixed screws removed earlier until the
stainless steel sheet no longer moves.
Loosely tighten the fixed screws removed earlier just to hold the
stainless steel sheet movement.