IAI America LSA-L15SS - Manual (Page 39)

2. Installation
33
2.3.2 Installation of Main Unit
Caution: The stainless steel sheet is designed very thin (thickness: 0.1 mm) in order to
ensure flexibility. Therefore, the stainless steel sheet is easily dented or
scratched.
When installing the stainless steel sheet, pay attention to the following points:
1. Do not press the sheet directly with hands.
2. Be careful not to drop a tool or a work piece on the sheet and make a dent mark.
Dent
3. Do not generate powder dust or iron powder around the stainless steel sheet.
There are magnets attached on the side cover to grip the stainless steel sheet. Handle
the product with special care so the magnets would not grip metal pieces and dusts.
If dust/powder has generated, thoroughly remove attached dust/powder from the
stainless steel sheet after the operation.
If the actuator is operated with the stainless steel sheet carrying foreign particles, the
particles may enter the slider and damage the sheet or cause the sheet to deform, lift or
present other problems.