IAI America RCS2-GR8 User Manual

Page 30

2. Installation

2.3.2 Installation

[1] Installation of the Main Unit

There are T-shaped grooves for M6 on the right and left of the base. Utilize these T-slots for the

attachment of bracket and other equipments by putting in nuts and tightening with screws.

Nut

M6 T-nut (recommended) or square nut

Screw M6�8

(Note 1)

Note1 Thread length should be 8mm maximum due

to the T-slot depth. Select a screw with a

thread length that is equivalent to the

thickness of screw seat on the attached part

+ 8mm.

[2] How to a Insert Nut

To insert a nut to the T-slot, the side cover needs to be removed.

Remove the screws securing the side cover.

Slide the side cover in the arrow direction to take off.

3) Put a nut in the T-slot, and slide in the side cover to the opposite direction of the arrows to put

back.

4) Tighten the screws.

Detail A

Screw

Side Cover