IAI America RCS2-GR8 - Manual (Page 11)

5
No.
Operation
Description
Description
6 Trial Operation � When the work is carried out with 2 or more persons, make it clear who is
to be the leader and who to be the follower(s) and communicate well with
each other to ensure the safety of the workers.
� After the teaching or programming operation, perform the check operation
one step by one step and then shift to the automatic operation.
� When the check operation is to be performed inside the safety protection
fence, perform the check operation using the previously specified work
procedure like the teaching operation.
� Make sure to perform the programmed operation check at the safety
speed. Failure to do so may result in an accident due to unexpected
motion caused by a program error, etc.
� Do not touch the terminal block or any of the various setting switches in
the power ON mode. Failure to do so may result in an electric shock or
malfunction.
7 Automatic
Operation
� Check before starting the automatic operation or rebooting after operation
stop that there is nobody in the safety protection fence.
� Before starting automatic operation, make sure that all peripheral
equipment is in an automatic�operation�ready state and there is no alarm
indication.
� Make sure to operate automatic operation start from outside of the safety
protection fence.
� In the case that there is any abnormal heating, smoke, offensive smell, or
abnormal noise in the product, immediately stop the machine and turn
OFF the power switch. Failure to do so may result in a fire or damage to
the product.
� When a power failure occurs, turn OFF the power switch. Failure to do so
may cause an injury or damage to the product, due to a sudden motion of
the product in the recovery operation from the power failure.