SKC 100-3000 Leland Legacy - Manual (Page 8)

5
Battery Charging
Reading the Charging Status LED on the Single Charger
The Li-Ion Charging Unit (Cat. No. P22300) indicates batt ery charge status
via an LED on the unit that blinks in specifi c patt erns. Observe the LED
steadily for > 5 seconds to read charge status.
LED Action Charge Status
ON

steady
Charge in progress
ON

2 sec
OFF

.25 sec
ON

2 sec
(Repeats) Approximately
80% charged
OFF

2 sec
ON

.25 sec
OFF

2 sec
(Repeats) Charge completed
The batt ery pack may be kept on SKC-approved Li-Ion batt ery
chargers for an indefi nite time.
Caution:
• Use only the SKC-approved charger for this pump. Use of an
unapproved charger may damage the battery and pump and
VOID ANY WARRANTY.
• Tampering with the battery pack VOIDS ANY WARRANTY.
• Do not charge in hazardous locations.
• Do not operate the pump with or without the charger in hazardous
locations.
• Do not open, disassemble, short circuit, crush, incinerate, or expose
the battery to fi re or temperatures in excess of 212 F (100 C).
• Failure to follow warnings and cautions voids any warranty.
For more information on SKC pump batt ery packs,
go to www.skcinc.com/instructions/1756.pdf.
Determining Pump Battery Status
Three bars indicate a full charge (normally appears aft er charging),
approximately 75 to 100%.
Two bars indicate that the batt ery is charged enough to operate the
pump, approximately 25 to 75%.
One bar indicates batt ery charge is low (charge batt ery),
approximately 1 to 25%.
Low Battery Fault
No bars and a fl ashing outline indicate a Low Batt ery Fault mode
(pump will go into Hold).
Power supply
jack
Charge status
LED