SKC 100-3000 Leland Legacy - Manual (Page 2)

Leland Legacy Quick Guide
Terms »
Star button 
• Scrolls through run time data and Setup options
Up and down arrow buttons 
• Toggle between display choices and increase or decrease sampling parameters in Setup
Button sequence
  = press buttons individually
[] = press simultaneously
 = security code, always press in sequence
Security code 
• Prevents unauthorized changes to the pump’s sampling program
Programming Sequences »
• To activate pump (e.g., to change pump from Sleep to Hold):
Press any button.
• To change pump from Hold to Run or Run to Hold:
Press [].
• To reset accumulated data:
Press [], then . Press  until CLr displays then press []; press  until End
displays then press [].
• To set pump fl ow rate:
Press [], then . Flow rate and SET fl ash. Press  or  to change fl ow rate. Press 
until End appears then press [] to save setting and place pump in Hold.
• To calibrate fl ow rate with standard calibrator:
Press [], then . Flow rate and SET fl ash. Press  or  to change fl ow rate. Press 
once. ADJ displays. Press  or  until desired fl ow rate is indicated on calibrator. When fi nished,
press  until End displays then press [] to save new setting and place pump in Hold. For CalChek
Calibration, see operating instructions.
• To change temperature scale from F to C or C to F:
Press [], then . Press  until temperature displays. Press  or  to switch units;
press  until End displays then press [] to save new setting.
• To change atmospheric pressure scale (mm, mb, In):
Press [], then . Press  until pressure displays then press  or  to switch units;
press  until End displays then press [] to save new setting.
• To change time scale (12 Hr/24 Hr/Dela):
Press [], then . Press  until 12 Hr, 24 Hr, or Dela displays then press  or  to
switch units; press  until End displays then press [] to save new setting. To set delayed start
(Dela), see operating instructions.
• To change clock:
Press [], then . Press  until clock displays then press  or  to change fl ashing
hour; press  to move to minutes and  or  to change setting. Press  until End displays then
press [] to save new setting.
• To change the sampling time function:
Press [], then . Press  until ST L/min displays then press  to change fl ashing digit;
press  until End displays then press [] to save new setting. To delete, follow above steps and
press  until 0 appears. Exit Setup.
Note: When in Setup, choosing Esc instead of End will exit Setup without saving new settings.
SKC Inc., 863 Valley View Road, Eighty Four, PA 15330 • www.skcinc.com