Securitron DT-7 - Manual (Page 6)

PN# 500-11800
Page 6 Rev. C, 02/11
from other manufacturers will work (be sure to specify a 6 volt DC coil). This relay physical type
is very common.
FIG. 3: PRIME TIME WIRING EXAMPLES
1 2 3 4
C C NC NC NO NO
POWER SUPPLY
12-24 AC/DC
PRIME
TIME
1 2 3 4
C C NC NC NO NO
POWER SUPPLY
12-24 AC/DC
PRIME
TIME
1 2 3 4
C C NC NC NO NO
POWER SUPPLY
12-24 AC/DC
PRIME
TIME
LOAD
NOTE: JUMPER BLOCK SET TOJ1
NOTE: LOAD USES SAME POWER AS DT-7.
IF LOAD REQUIRES DIFFERENT POWER,
SUCH AS 115 VAC, RELAY CONTACTS
SHOULD BE ISOLATED FROM DT-7 POWER.
TYPICAL WIRING: TOGGLE MODE
TYPICAL WIRING: DOUBLE PULSE MODE
USE WITH ALARM PANEL SHOWN
ALARM PANEL
NOTE: JUMPER BLOCK SET TO J2
PANEL ARMS AND DISARMS AS DISPLAY
MODULE SWITCHES ON AND OFF
TYPICAL WIRING: TOGGLE MODE WITH FIRST MAN IN ACTIVE
USE WITH ELECTRIC LOCK AND DIGITAL KEYPAD FOR TIME CONTROLLED ENTRY SHOWN
FAIL SAFE
ELECTRIC LOCK
C NC
NC C
DOUBLE POLE KEYPAD
OUTPUT RELAY.
OPERATES WHEN CODE
IS COMPOSED.
POSSIBLE SHUNT
OF DOOR CONTACTS
CONNECTED TO
ALARM SYSTEM
NOTE: JUMPER
BLOCK SET TO J1
KEYSWITCH
(ARM) INPUT
NOTE: SEE PARAGRAPH 6 IN INSTRUCTIONS FOR FULL EXPLANATION OF FIRST MAN IN FUNCTION