Securitron EASB_Series - Manual (Page 4)

PN# 500-18100
Page 4 Rev. D, 08/11
7. Hole Drilling Difficulty
If there is an obstruction, which doesn’t allow proper drilling of the mounting hole in the door,
reposition the Magnalock and the EASB further back from the door stop. If lowering the
Magnalock is necessary, Securitron manufactures two (2) types of 1/2” [12.7mm] thick spacer
brackets (Models: ASB or CWB).
Contact the factory
8. Retrofit An Existing Installation
Remove the strike and remove the sex bolt from the door installation. To enlarge the original sex
bolt hole, use a block of wood as a template. Drill the desired size hole, 1-1/4” [31.8mm]
diameter for EASB-32 or 2” [50.8mm] diameter for the EASB-62/82 into the block of wood.
Carefully position and clamp the template block into place over the center of the existing hole or
in the desired center mounting location for the EASB. Using the Hole Saw desired, enlarge the
mounting hole.
Note: Be cautious to maintain alignment when drilling the hole into the door.
9. MAGNACARE
 LIFETIME REPLACEMENT WARRANTY
For warranty information visit: www.securitron.com/en/site/securitron/About/MagnaCare-Warranty/