Reese 61300 SIDEWINDER - Manual (Page 2)

Installation Instructions
Sidewinder Turret TM
z 2009 Cequent Performance Products Sheet 2 of 3 61300 12/08/2010 Rev. A
Form: F205 Rev A 5-6-05
Figure 3
Trailer Forward
For Wing Set Make and Model Numbers:
Lippert 1716
Lippert 1116
Lippert 0115
Use The Bolt Hole Locations Noted By The “B”
The pattern is a 8.75” horizontal & a 2.5” vertical
For Wing Set Make and Model Numbers:
Fabex PB-500 Series
Note: For the 500 series only one row is needed.
(2 Bolts per Side)
Fabex PB-700 Series
Use The Bolt Hole Locations Noted By The “C”
The pattern is a 9.5” horizontal & a 2” vertical
Note: Spacer Kit 61301 Is Needed For These Model Wings
Figure 4
Trailer Forward Note: Spacer Kit 61301 Is Needed For These Model Wings
Typical Bolting
Hardware Kit Contains: (8) 5/8-11x2 Gr.8 Bolts / (8) 5/8-11 Gr.8 Nuts / (8) 5/8 HD Flat Washers / (8) 5/8 Conical Lock Washers
Matching Wing Sets
Bolts & Flat Washers Are Installed From The Outside, Conical Lock Washers and Nuts On the Inside.
Torque All To 210 ft. lbs.
5/8-11 Gr.8 Nut
5/8-11x2 Gr.8 Bolt
5/8 Conical Lock Washer
Typical Wing
5/8 HD Flat Washer