Reese 61301 SIDEWINDER - Manual

Installation Instructions
Spacer Kit for Sidewinder Turret
TM
Part Number:
61301
Turret Shown w/Spacer Kit Installed
Equipment Required:
Drill Bits: Not Required
Torque Wrench
Qty. (1) Turret 61300 (Formally ST100 & ST200)
Qty. (2) Spacer Plate
Qty. (4) Roll Pin
Fastener Kit: 61301F
Do Not Exceed Lower of Towing Vehicle Manufacturer’s Rating,
Trailer Manufacturer’s Rating or
Max Gross
Trailer WT (LB)
Max Pin
WT (LB)
19,500 LB 3,900 LB
DEALER/INSTALLER:
(1) Provide this Manual to end user
END USER:
(1) Read and follow this Manual for Sidewinder Turret Installation.
(2) Save this Manual for Future Reference.
(3) For Sidewinder Arm Installations, Refer to there Installation Manuals.
(4) Pass on copies of Manual to any other users or owner.
Figure 1 2
1
2
Note: These Instructions Are Only For Installation Of Turret Into Wing Sets.
You Should Refer To The Installation Instructions For Your Sidewinder Arm.
Hammer
INDEX
1. ASSEMBLING SPACERS ON TURRET P. 1
2. GUIDELINES FOR MATCHING WING SET P. 2
3. 5 YEAR LIMITED WARRANTY P. 3
2009 Cequent Performance Products Sheet 1 of 3 61301 12/08/2010 Rev. A
Qty. (4) Roll Pin
Form: F205 Rev A 5-6-05
WARNING:
Failure to follow all of these instructions may result in death or serious injury!
3
2
Figure 2
Position spacer plate (2) onto side of turret (1).
Align holes (A) on spacer plate and turret.
Install roll pin (3) into hole. Tap with hammer
until flush with surface on the outside of turret.
* You must install one spacer plate on each side of
turret. Spacer plates can be used on either side.
* Note: There are two notches in the spacer plates
they must be at the bottom.
Assembling Spacers
A
A A