Reese 59711 ROOF RACK - Manual (Page 2)

STEP 3: Placement of Under Cover
A. Push Locking Mechanism Handle back into the End
Support and secure by turning the locking device.
Measure the space under the bars in front of and
behind the End Supports. Using scissors cut the Under
Cover strips to each measured length (Fig 3a) and push
the under cover into the channel by inserting one side
first and then push the other side into place making sure
that it sits flat when properly installed.
Note: Installing the Under Covers is optional but will reduce
potential wind noise.
Check Fit is secure by grabbing the Cross Bar and
applying forces in upwards and sideways motions. If any
movement occurs repeat steps 2b & 2c while also
further tightening the Handle. Visually check to see that
the Locking Jaw is firmly pressed against the vehicles
side rails on all four End Supports (Fig 3a).
Note: If a Security Lock Kit is to be added please refer to our
Lock Kit’s instructions for installation instructions. It is
advised to record the key combination so replacement
keys can be ordered in case of misplacement or loss.
Key Number: _ _ _
C. Be sure the distance between the cross bars front to
back is at least 700.0mm (27 ½”) Fig 2c.
D. Turn the locking handle in a clockwise direction to
tighten the end support to the vehicles side rails (Fig
2d). The handle must be firmly turned (Equivalent to
5Nm or 44 in/ lbs) to achieve a positive and tight fit.
Always turn the handle clockwise until horizontal to
align the lock with the internal locking position. At the
same time the locking jaw is tightened the end support
will clamp the cross bar into position. Repeat this
procedure on all end supports.
Note: To release the cross bar from the vehicle side rails
simply rotate the locking mechanism handle counter-
clockwise. Additional movement of the locking jaw with
your hand will assist the release of the end support.
Any weight carried on the vehicle will adversely affect its handling particularly in cornering or in a cross wind and the vehicle should therefore be driven
with increased caution. Check the function of all doors and sunroof before driving. For lost key replacement or other service items call customer service:
1-800-632-3290 or visit:
www.rolaproducts.com Please have lock core number or part numbers available.
REGULARLY CHECK THE TIGHTNESS OF LOCKING JAWS.
Loads should be evenly distributed and secured
.
Ensure bars are parallel and jaws are tightened against the side rails.
Perform a check by tugging on the cross bars.
A number of accessories for carrying special loads are available. Only use NON-STRETCH tie down straps.
FITTING INSTRUCTIONS:
Rail Bar Universal (RBU)
PART No:
59897-8-9N Date: 6/3/2011
Pg2 of 6
Printed In China
Fig 2c.
Slide Cross Bar
back or forth until
overhang is equal
Measure
overhang on
both sides
Tighten
Release
Vehicle Rail
Fig 2d.
Fig 3a Inset
Front Behind
Fig 3a
Locking Jaw firmly
pressed against
the vehicle rail
Fig 2d Inset
44 in/ lbs
Final
assembled
view
59897 / 59898
/ 59899 / 59711