Reese 30033 22K FIFTH WHEEL - Manual (Page 4)

WARNING:
Do Not use this hitch for towing a trailer with a pin box that could come into contact with
or interfere with the latch for the hitch handle when turning! (See Fig. 6) If the pin box
contacts the hitch handle or its latch when turning, the trailer may become unhitched.
KING PIN
BOTTOM OF PIN BOX
LATCH
ASSEMBLY INSTRUCTIONS
WARNING:
• Connection for trailer wiring should be in the side of the truck bed between the driver’s
seat and the wheel well for the back truck axle
Fig. 6
• Installation of connection rearward of the wheel well may result in user placing body
between truck and trailer. WHENEVER POSSIBLE, AVOID PUTTING BODY UNDER
TRAILER OR BETWEEN TRUCK AND TRAILER!
• If you need to place any part of your body under trailer or between truck and trailer:
• All trailer tires MUST be blocked in front and behind each tire AND
• Trailer landing gear MUST be resting on firm ground AND
• Truck MUST be stationary, in park, with emergency brake on!
1. Reference Fig. 19 on back page. Numbers in parentheses refer to parts in Fig. 19.
2. 5th Wheel Kit is contained in two cartons. Unpack and become familiar with parts on parts list. Base rails, brackets and
hardware are in separate kit (part no. 30035) with separate Installation Instructions for Fifth Wheel Rail Mounting Kit.
3. Place two base rails (25) across bed of truck (See Fig. 7). Select base (28) and place tabs through the second
rectangular slot from the end of the base rails Slip long pull pins (11) through holes in base rails from the inside out as
Truck MUST be stationary, in park, with emergency brake on!
rectangular slot from the end of the base rails. Slip long pull pins (11) through holes in base rails from the inside out as
shown so the pull pins are on the outside of the base rails. Repeat for other side. Secure pull pins with spring retaining pins
(12).
Fig 7
BASERAILS
4. Select head support (27) and install on base aligning holes for hitch height desired. (Lowest position 14" highest 18"). Install
four 1/2-13 x 1.5" rib-neck bolts (33), (with heads toward inside as shown), lock washers (30), and hex nuts (31).
5. Torque 1/2" nuts to 85 lb. ft.
6. Install base rails and mounting brackets as described in "Installation Instructions for 5th Wheel Rail Mounting Kit,”
P t # 30035
Fig. 7
30033IN-OCT 28,2008 F PCN11465 ©2005 CEQUENT TOWING PRODUCTS, INC LITHO IN USA
4
Part # 30035.
WARNING
Base rails must be bolted through the floor of the pickup to the brackets that attach to
the truck frame. DO NOT INSTALL BY FASTENING TO THE FLOOR OF THE PICKUP BOX
ONLY. The floor alone is not strong enough to carry the loads imposed by the trailer.