beautypg.com

Reese 33070 PROFESSIONAL RECEIVER User Manual

Installation instructions, Toyota sienna, Part numbers

background image

Installation Instructions

Toyota Sienna

2011 and newer models: Hitch crosstube is visible beneath

bumper with a more than normal gap between fascia and crosstube.

Part Numbers:

33070

75149

87415

Do Not Exceed Lower of Towing Vehicle

Fascia

78270

U-Haul

Hitch Shown In Proper Position

Equipment Required:

Wrenches: 19mm

Fastener Kit: F75149

Manufacturer’s Rating or

Wiring Access Location: SUV1, SUV2

Frame Rail

Hitch type

Max Gross

Trailer WT (LB)

Max Tongue

WT (LB)

Weight Distributing

5,000

500

Weight Carrying

Ball Mount

3,500

350

To be reinstalled

Wrenches: 19mm

Drill Bits: None

Existing Weldnut
3 Places
(Both Sides)

Area to be trimmed

To be reinstalled

Note:
Fasteners Typical
Both Sides

Area to be trimmed

To be reinstalled

Figure 2

Sport Model

1

Qty. (6)

Flat Washer, 1/2”

3

Qty. (6)

Hex Bolt, M12 x 1.25 x 40mm

2

Qty. (6)

Lock Washer, 1/2”

Area to be trimmed

Figure 1

For vehicles with appearance panel:
Remove appearance panel which covers the trunk pan. This panel will need to be trimmed or not reinstalled on vehicle. Ask vehicle
owner their choice before starting installation. See Figure 2

1. Lower the exhaust by detaching it from the rubber isolator.
2. Raise hitch into position and install hex bolts, lock washers and flat washers into existing weldnuts in frame, as shown above.
3. Raise exhaust back into position and reattach to the rubber isolator.
4. Reinstall trimmed cover panel removed. Or return untrimmed panel to vehicle owner.

z

2006, 2007, 2008, 2010, 2011

Cequent Performance Products

Sheet 1 of 3

N75149

1-7-11

Rev. E

Tighten all M12 CL10.9 fasteners with torque wrench to 75 Lb.-Ft (102 N-m).

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to

prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working

beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5

and SAE J684.