Reese 44536 PROFESSIONAL RECEIVER - Manual

Between bumper bracket and
hitch side-brkt. As required.
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 3/4”, 7/8”
Drill Bits: None
3/16” X 2-1/8” X 2-1/8” Block-round hole,
(2500 & 3500 long box only)
Qty.
(2)
1/2” Hex Nut
Qty.
(6)
5
1/4” X 2” X 2” Block-square hole
Qty.
(2)
9 1/2” Lockwasher
Qty.
(6)
4
1/4” X 1-1/2” X 3” Block
Qty.
(2)
8 1/4” X 1-1/2” X 2” Block
Qty.
(2)
3
1/2”-13 X 1-3/4” GR. 5 Carriage Bolt
Qty.
(4)
7 1/2” Flat Washer
Qty.
(2)
2
3/8” X 1-1/2” X 3” Block, (use as needed)
Qty.
(2)
6 1/2”-13 X 2 1/4” GR. 5 Hex Bolt
Qty.
(2)
1
Fastener Kit: 75420F
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
600 (272 Kg) 6,000 (2724 Kg)
Weight Carrying
Ball Mount
1,000 (454 Kg) 10,000 (4540 Kg) Weight Distributing
Max Tongue
WT (LB)
Max Gross
Trailer WT (LB)
Hitch type
Wiring Access Location: PU 3
Fishwire carriage
bolts thru slots in
frame; both sides.
See figure 3.
Use these holes for
long-bed.
Use these holes for
short-bed.
FIGURE 1
Push/slide
¼” thick
blocks thru
end of frame,
both sides.
Use this slot for
2500/3500 models.
Typical both sides.
Use this slot for
1500 models.
Typical both
sides. See figure 2
See figure 4
Hitch side
bracket.
Vehicle bumper bracket.
FIGURE 2
Bumper
Frame
10
10
10
NOTE! Use blocks
(Item 10) on long box
2500 & 3500 only.
NOTE! Orient blocks (Item 10) as
shown
Installation Instructions
Dodge Ram Trucks-all without O.E.M. hitch
Part Numbers:
44536
75420
82534
Rev. D 6-23-06 75420N Sheet 1 of 6 z 2005, 2006 Cequent Towing Products
Tighten all 1/2” GR5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body
panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety
precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C.
Regulation V-5 and SAE J684.