Reese 44687 PROFESSIONAL RECEIVER User Manual

Installation instructions, Bmw x3, Part numbers

Installation Instructions

BMW X3

Part Numbers:

75768
87632
44687

Hitch Shown In Proper Position

Equipment Required: Utility knife, tape measure & marking pencil,
plastic rivet gun, small punch, optional auto trim tools.

Wrenches: 8mm.,10mm, 10mm deep socket, 18 mm
deep socket, flat screwdriver

Fascia

Galvanic isolator

Qty. (8)

Plastic rivet

Fastener Kit: 75768F

Do Not Exceed Lower of Towing Vehicle

Manufacturer’s Rating or

Hitch type

Max Gross

Trailer WT (LB)

Max Tongue

WT (LB)

Weight Distributing

4000 (1816 Kg)

400 (182 Kg)

Weight Carrying

Ball Mount

3500 (1589 Kg)

400 (182 Kg)

Wiring Access Location: SUV1&2

Accessory Rating

Threaded studs

End panel

Aluminum bumper

Existing flanged nuts

Rearward

Tighten all M12 fasteners with torque wrench to 65 Lb.-Ft. (88 N*M)

Sheet 1 of 6

75768N

1-31-13

Rev. A

Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent

entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a

vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and

SAE J684.

Form: F205 Rev C 9-17-2012

Step 2

Step 3

Step 4

Step 8

Step 2

Step 4

Step 8 Remove bolt

Open tailgate to gain access to the rear taillights assembly.

Using small screwdriver or a trim panel tool remove the plastic, covering the

fasteners.

Remove the (2) nuts holding the taillight in place. Then carefully remove the taillights

assembly using flat bladed screwdriver to gently walk the taillight off the threaded

post. Unplug the taillight from the vehicle wiring. Both sides.

Remove the rear reflector from the rear fascia, being careful not to scratch the fascia.

See next page for continuing instructions