Ransburg Vector Solo AA90 79698 - Manual (Page 21)

Vector Solo AA90 Applicators - Operation
Ransburg
17 AH-08-04.2
Figure 11: Air Cap Alignment Locating
Pin Position
Figure 12: Pre-Orifice Seal Sizes Dash
Number Location
6. The AA90 Applicator incorporates a new feature,
that being a locating air cap. (Refer to Figure 11
for a view showing the locating pin.) This feature
gives the capability to spray with a fan pattern in
either horizontal or vertical positions.
7. Table I shows the available tip sizes. Table
II shows the available pre-orifice sizes. The
pre-orifice selected should be sized approximately
.025mm (.001-inch) at 65 bar (1000 psig) pressure
flowing larger then the tip size opening. The
pre-orifice use can significantly increase useful
spray life of the tip.
Nozzle
Identification
79691-0509
79691-0511
79691-0513
79691-0811
79691-0813
79691-1009
79691-1011
79691-1013
79691-1015
79691-1018
79691-1021
79691-1311
79691-1313
79691-1315
79691-1318
79691-1511
79691-1513
79691-1515
79691-1518
79691-1521
79691-1715
5-in (127)
8-in. (203)
10-in. (254)
13-in. (330)
15-in. (381)
17-in. (432)
AA90 Fluid
Nozzle
Part #
Pattern
Width at
10-in. (mm)
Nozzle
Orifice Size
in Inches
(mm)
.009 (.23)
.011 (.28)
.013 (.33)
.011 (.28)
.013 (.33)
.009 (.23)
.011 (.28)
.013 (.33)
.015 (.38)
.018 (.46)
.021 (.53)
.011 (.28)
.013 (.33)
.015 (.38)
.018 (.46)
.011 (.28)
.013 (.33)
.015 (.38)
.018 (.46)
.021 (.53)
.015 (.38)
Operating
Parameters
TABLE I
NOZZLE SELECTION GUIDE
The first two digits of the nozzle dash number
indicate the spray pattern width in inches at a
distance of 10- inches (254mm) from the target.
The second two digits indicate the orifice size in
thousandths of inches.
For example: 79691-1015 has a 10-inches
(254mm) spray pattern width and an orifice size
of 0.015-inches (.38mm).