Ransburg Vector Solo 79900 Solventborne RS90-AS - Manual (Page 57)

53
Vector Solo Applicators - Parts Identification
Ransburg
Figure 97: Install Power Module On Handle
† Hose may need to be trimmed to proper
length (approximately 213mm (8 3/8") mea-
sured from the top face of the bracket.
NOTE
Figure 98: Install Hose Onto Barrel
79837-00 Gasket, Handle to Power Module
79832-00 Gasket, Barrel
79836-00 Gasket, Exhaust
79881-00 Gasket, Exhaust, Wraparound
79876-00 Label, Voltage On/Off, Solo
79658-00 GASKET KIT -
PARTS LIST
Description Part #
The 79658-00 Gasket Kit is available for the Vector
Solo. This kit includes all of the gaskets required
for an applicator rebuild.
The 79651-00 Installation and Setup Kit is avail-
able for the Vector Solo. This kit includes all
equipment necessary for the installation, setup,
and maintenance of the Vector Solo applicator.
This kit includes:
Figure 99: Installation and Setup Kit
1 Cap Pressure Test Gauges
2 Test Air Caps (65V, 98V, 122V)
3 100 ml Graduated Cylinder
4 Analog Voltmeter
5 Stop Watch
6 Test and Maintenance Kit
7 Wet Film Gauge
79651-00 INSTALLATION AND
SETUP KIT - PARTS LIST
Description Item #
d. Re-install the power module onto the handle
and tighten the three (3) screws.
e. Place the connector nut [6] and two (2)
ferrules [7 and 8] onto the short stopper hose.
Insert hose into the barrel and tighten the con-
nector nut [6].
AH-08-01.10