Short stopper hose assembly, Ransburg, Vector solo applicators - parts identification – Ransburg Vector Solo 79900 Solventborne RS90-AS User Manual
Page 54: Short stopper assemblies
Vector Solo Applicators - Parts Identification
50
Ransburg
SHORT STOPPER HOSE
ASSEMBLY
A short stopper hose assembly is now available for
the Vector Solo applicator. The short stopper is used
when the coiled fluid tube (p/n 79871-00) does not
adequately isolate highly conductive solvent based
materials from ground. In those applications, the
short stopper is used. The following assemblies are
available for purchase:
77821-12 1.2m (4') Long 3/16" ID Grounded
Fluid Hose Assembly
77821-30 3.0m (10') Long 3/16" ID Grounded
Fluid Hose Assembly
77821-76 7.6m (25') Long 3/16" ID Grounded
Fluid Hose Assembly
77822-12 1.2m (4') Long 1/4" ID Grounded
Fluid Hose Assembly
77822-30 3.0m (10') Long 1/4" ID Grounded
Fluid Hose Assembly
77822-76 7.6m (25') Long 1/4" ID Grounded
Fluid Hose Assembly
SHORT STOPPER ASSEMBLIES
Part #
Description
In order to use these short stopper hoses, the
conductive fluid conversion kit (79891-00) must be
purchased as well.
In order for the short stopper assembly to work
properly, it must be correctly installed onto a cur-
rent Vector Solo applicator. The following steps
describe how to convert a standard Vector Solo
applicator to use a short stopper assembly.
Converting a Standard Vector Solo
To Use a Short Stopper Assembly
1. First, remove the fluid tube from the fluid fitting.
Second, remove the three (3) screws from the
base of the power module. Finally, remove the
power module from the handle by pulling straight
down.
Figure 87: Conductive Fluid Conversion Kit
Figure 88: Remove Power Module From Handle
Figure 89: Remove Screws
2. Next, remove the two (2) screws from the sides
of the power module.
AH-08-01.10