Ransburg Vector Solo 79900 Solventborne RS90-AS - Manual (Page 56)

Vector Solo Applicators - Parts Identification
52
Ransburg
7. Install the short stopper hose into the hose
bracket following these steps:
1 Short Stopper Hose
2 Bulkhead Connector
3 Conductive Ferrule
4 Thin Jam Nut
5 Nylo-Seal Nut
6 Connector Nut
7 Ferrule, Front, 3/8" Tube
8 Ferrule, Back, 3/8" Tube
SHORT STOPPER HOSE
ASSEMBLY PARTS LIST
Description Item
Figure 94: Short Stopper Hose Assembly
† Make sure to align the pin on the bulk-
head connector [2] with the hole on the
hose bracket [9].
NOTE
Figure 95: Install Hose Into Bracket
Figure 96: Tighten Hose Onto Bracket
a. Remove the two (2) ferrules [7 and 8], connector
nut [6], Nylo-Seal nut [5], and the thin jam nut [4]
from the short stopper hose [1]. Do not discard.
These pieces will be reinstalled onto the short
stopper hose.
b. Insert the short stopper hose [1], with the
conductive ferrule [3], and bulkhead connector
[2] still on the hose, throught the hole in the hose
bracket [9].
c. Tighten the thin jam nut [4] onto the bulkhead
connector [2]. Tighten the Nylo-Seal nut [5] onto
the bulkhead connector [2].
AH-08-01.10