Fairbanks H90-5200-A Digital Instrument User Manual
Page 7
FIGURE 1-2:
C. Keypad Description
The functions of the front panel keys vary depending on the mode in which the
instrument is operated. This Subsection defines the operation of each front panel key.
Refer to Figure 1-2.
START: Initiates setpoint batching operation to pre-selected setpoint weight.
Batching modes only.
TRIM : Overrides setpoint control to add additional weight in touch controlled
increments. Manual batch mode only.
STOP: Overrides setpoint control cycle to turn off all set points, in batching
modes only. During batching it is used to change selected setpoint(s) for
subsequent batching operation.
ID: Up to a 6 - digit product ID for printer/computer print out, not maintained at
power loss.
TARE RECALL: Tare retrieval. Displays current tare for aprox. 5 seconds.
FUNC: Press function key and then one of the following keys to enter special
modes described below. Up to six digit security code is then required (if
security code entered does not equal 0) to change displayed value using
keypad. Refer to Section 2 for further information on all function key
operations.
50515
7
Issue #2 4/04
.
9
7
4
1
2
3
0
8
5
6
PROG
TIME
CLEAR
ENTER
TEST
DATE
4-20mA
I/O
lb
kg
NET
TARE
ID
= CENTER OF ZERO
ID
TARE
RECALL
AUTO
TARE
GROSS
NET
UNITS
ZERO
FUNC
SET PT
ENABLE
SP 1
SP 2
SP 3
SP 4
START
TRIM
STOP
SET POINTS
3050
ST ART
TRIM
I D
T ARE
RECALL
FUNC