Fairbanks H90-5200-A Digital Instrument - Manual (Page 31)

* All commands must be terminated by a and . Upon receipt, the
command will be executed.
* The Command String (including the and , and ID if required) may not
be longer than 20 characters. IF the string is longer than 20 characters, the extra
characters will be lost.
* If a Scale ID other than 0 (Section 2, B-13) has been entered, the Command
must be preceded by a 1-3 digit Scale ID or it will be ignored. If a Scale ID other than
0 has been entered and weight is outputted, the weight output string will be preceded
by a Scale ID String.
* Buffer will be cleared after command is executed.
* Computer commands may be echoed and /or acknowledged. Refer to Subsection I,
of this section for further information.
Example Command : 12P
Response : SCALE 12
Weight is output to all printer channels The following computer commands are
supported. Refer to Appendix V (Data Format) for output string information.
PRINT P
Weight is output to all printer channels
WEIGHT W[L/K]
Weight is output to computer channel requesting data only L(LB)
OR K(KG) can be used to request output in specific weight unit
ZERO Z
Scale is zeroed IF no motion
NET N
Scale is switched to net mode IF tare is enabled
GROSS G
Scale is switched to gross mode
AUTOTARE A
Scale is Autotare IF Autotare is enabled
START B
Batch cycle is started
STOP SBatch cycle is stopped
DISCHARGE D
50515 31 Issue #2 4/04