Fairbanks H90-5200-A Digital Instrument - Manual (Page 5)

6. Display: High visibility, 6 digit LED display, with 0.8 inch digits.
Separate indicators for:
Left Side Display Right Side Display
SP Enable lb
SP 1 kg
SP 2 NET
SP 3 TARE
SP 4 ID
Center-of-Zero Indicator appears in the display.
7. Display update rate: Programmable for 0.1, 0.3, 0.5, 0.8 or 1.0 seconds.
8. Digital Filter: Programmable - 5 levels
9. Tare: 10 key numeric TARE entry or Auto Tare entry, TARE operation(s) may be
disabled in the setup mode.
10. Programmable Features: Primary Units, Scale ID, Time and Date in Military, US,
and International Formats, Security Code, Switch Inhibit, and remote switches.
11. AUTO-ZERO tracking: Programmable OFF, 0.5d, 1 .0d, or 3.0d
12. Auto-Zero Time Delay: Programmable from 1 to 6 seconds.
13. Re-zero Range: Programmable +/- 2% or 100% of capacity
14. Overcapacity Warning: The display will show “—OL—” if the weight exceeds
105% capacity
15. Underload Warning: The display will show “—UL—” if the weight on the platform is
below the A/D input range.
16. Balance/Motion band: Programmable 0.5,1.0, 2.0, 3.0d
17. Controls: 23 key keypad
18. Setpoints: Four setpoints with open collector outputs rated at 60VDC @ 100mA.
Setpoint status is shown by 4 LED indicators, one indicator to show the setpoints
are active, and a separate indicator for each setpoint to show its status.
Setpoint mode available with dribble, preact, discharge and zero band.
Checkweigh modes available with preact, discharge and zero band.
Batch modes available with dribble, preact, discharge, zero band and setpoint
inhibit.
50515 5 Issue #2 4/04