Teledyne 9110T - Nitrogen Oxides Analyzer - Manual (Page 145)

Model 9110TH NOx Analyzer Communications Setup and Operation
Teledyne Analytical Instruments 145
SETUP X.X COMMUNICATIONS MENU
ID INET COM1 COM2 EXIT
SETUP X.X INST IP: 0.0.0.0
SET> EXIT
SETUP X.X GATEWAY IP: 0.0.0.0
SET> EXIT
SETUP X.X TCP PORT2: 502
SET> EDIT EXIT
EDIT button
disabled
From this point on,
EXIT returns to
COMMUNICATIONS
MENU
Do not alter unless
directed to by Teledyne
Instruments Customer
Service personnel
SETUP X.X HOSTNAME:
EDIT EXIT
SAMPLE ENTER SETUP PASS : 818
8 1 8 ENTR EXIT
SETUP X.X SUBNET MASK: 0.0.0.0
SET> EXIT
SETUP X.X TCP PORT: 3000
SET> EDIT EXIT
SETUP X.X DHCP: ON
SET> EDIT EXIT
DHCP: ON is
default setting.
If it has been
set to OFF,
press EDIT
and set to ON.
SETUP X.X DHCP: OFF
OFF ENTR EXIT
SETUP X.X DHCP: ON
ON ENTR EXIT
Figure 6-5. COMM – LAN / Internet Automatic Configuration (DHCP)
Note If the gateway IP, instrument IP and the subnet mask are all zeroes (i.e.,
“0.0.0.0”), the DCHP was not successful in which case you may have to
configure the analyzer’s Ethernet properties manually. See your network
administrator.